How to detect the failure of fuel pump

Fuel Pump

The main function of a fuel pump is to create a pressure in the fuel lines to push the gas into the engine. Fuel pressure implies the problem with a fuel regulator. So, without sufficient amount of fuel pressure engine trifles roughly and suspends at regular interval of time. Needless to say if the fuel pump halts completely, there will not be any fuel pressure and thus engine will not start.

If the problem persists then you should get your car checked by an experienced mechanic to treat the diagnosed dilemma adequately.

Here are the five reasons which can detect fuel pump:-

  1. If the engine gives the heavy thrust while running on full speed:- If the car shivers on the highway at full speed then it is a sense of failure of fuel pump. Some people refer this to the less availability of the fuel. This happens because the fuel pump is losing the adequate amount of fuel pressure which results to bouncing or shivering.
  2. Loss of power when car is in acceleration mode. Fuel pump may not work properly due to condemn amount of pressure resulting into improper fuel mix into engine ultimately leading to the fuel pump failure.
  3. During towing or one such task the car suddenly experiences a power loss. This could suspect as a failed fuel pump. The failure of delivering enough fuel can lead to this results.
  4. If the car suddenly starts to accelerates or moves forward without the driver mediation, then it is said to be wear and tear of fuel pump. Often people misunderstood this by the failure of fuel filter. Due to fuel pump failure pump fails to draw appropriate amount of electricity which causes fuel pressure to increase suddenly and engine bounces or jerks as a result.
  5. The engine may refuse to start.

This sign of a bad fuel pump is the most severe. If a car owner has not addressed that problem based on one of the signs above, eventually it will completely fail. When the fuel pump can no longer provide any fuel to the engine, the engine has nothing to ignite. There is no fuel to burn in the engine. It has failed and it must be replaced in order for the car to operate. Pay attention to how a car runs and how it sounds to catch potential issues early.

Fuel pumps are one of the more costly repairs car owners face, so fixing problems rather than replacing parts is a more cost effective choice.

EFI Hardware – Fuel Pump
7 Monomeeth Drive – Mitcham
Victoria – 3132
Phone – (03) 9873 5400
Fax – (03) 9873 5955

Author: EFI Hardware
Category: Automotive Spare Parts
Date: February 25, 2015
Comments:


2 Responses
  1. Very Good Article on detecting the fuel pump failure. I would recommend the readers to have a look at our EFI External Fuel Pumps. EFI Hardware supply Bosch Fuel Pumps, Walbro Fuel Pumps, Carter Fuel Pump, Denso Fuel Pumps, SX Fuel Pumps and Holley Fuel Pumps. We also supply specifically compatible E85 Fuel Pumps.

  2. Very Well Written Article. If I had read this an week earlier I might have saved $$ on my car. I left it long and finally have to put my car for Scrap.

Leave a reply

Your email address will not be published. Required fields are marked *



*